CeBeCo® ROWAMAT® “XP”
Pipe washing system in continuous cycle process
- Available for interlinking with sawing centres and endworking systems as well as stand-alone system
- With throughput rates of up to 4,800 pieces/hour, depending on interlinking and pipe dimensions
- With minimum set-up effort
- With energy-saving drying concept
Construction
The CeBeCo ROWAMAT “XP” is made of strong stainless steel sheet in welded construction and is available in six standard sizes. Intermediate or special sizes according to customer-specific request are possible. Water-based detergents are used as washing agents.
Equipment
Electric direct heating, high-pressure immersion pump, wash ware transport drum with direct drive, automatic transport system in the drying zone, drying device, vapour extraction, coarse filter basket, oil separator for non-emulsified oils in the bypass process, control panel, weekly clock.
Supplementary features
Ultra-fine filter in the main stream, circulation fine filter device in the secondary stream, air fine filtering, bottom protection trough, feed station (in a wide variety of designs), discharge pump.
Types
TYPE DESIGNATION |
RL50 |
RL100 |
RL150 |
RL200 |
RL250 |
RL300 |
Pipe lengths (MM) |
up to 500 |
up to 1,000 |
up to 1,500 |
up to 2,000 |
up to 2,500 |
up to 3,000 |
tube diameter (MM) |
possible from 8 to 90 mm depending on the system design. Square tube at extra cost accordingly. |
|||||
model variants
Examples of feeding stations
The illustrations on this page show also special equipment that are not included in the standard scope of delivery. The content corresponds to the status at the time of setting (10/20). We reserve the right to implement changes to construction and equipment. Screen colours only reproduce an approximation of the actual colour hue. Surcharge for the displayed special equipment. Screen colours only reproduce an approximation of the actual colour hue. Surcharge for the displayed special equipment.
